Best way to face lather with my setup?

So I am new to brush and soap. I have a maggard synthetic brush and sterling soap's orange chill (I know the scent doesnt matter but still). I heard it is good to "bloom" the soap. So I do that for about 1-2 minutes, pour the liquid into my hands and rub it on my face for a pre shave. I then get the brush wet, squeeze it gently yet firmly and go to load it.

Now here is my issue. The guy on youtbe loaded it for about 20 seconds, and then started face lathering and got good foam. My issue is this, it works too good. No joke 5-10 seconds into "loading" my brush in the soap it is already forming a very good lather. To the point where I have to stop and put it to my face. I dislike this because it makes a bigger mess of the counter and soap container than I would prefer. I press just hard enough to slightly spread the bristles and go in a circular motion.

I have read that this brush and this soap are both very good for an easy lather, do you think I should just skip the blooming process entirely? That would suck a little bit because I like the pre shave that it has to offer.

Not some huge issue by any means, I can get a 3 pass shave with clean up just fine like this, plenty of soap on the brush. Just curious!