Upgraded and restored old foamy flying wing with 3D printed fuse pod and fins

This flying wing was kept in a small shed for over a decade after being purched at Best Buy in the early 2000’s and crashed.

Finally got around to converting it to FPV properly.

3D printed PLA fuse pod, LW-PLA canopy with magnetic latch, TPU motor mount. LW-PLA fins. Also printed small TPU rings which hold on the original elevon horn clevis’.

Matek F405 FC with Radiolink GPS. Front and down facing cameras switchable with radio.

The old foam took glossy gun metal gray spray paint without any thermal reaction which was a bonus.