A Love-Letter to my X1 Carbon-Print Job Survives 3 Power Outages

Hey folks...this has probably been said a few times already, but I just can say enough good things about this printer!

I FOOLISHLY started a 3 hour print this morning, knowing full well that the weather forecast was gonna be sketchy. Pacific Northwest has had a full week+ of freezing temps!

The power went out about an hour into the print, but quickly came back on. The printer asked me if I wanted to resume the print and I SKEPTICALLY pressed continue. Low and behold it just picked up right where it left off...couldn't even see a conspicuous layer line where it got interupted!

This happened two more times during the print, with the machine recovering each time!

Thank you Bambu Lab for making this sucker as bullet-proof as it is! I continue to be super impressed with it, and this disaster recovery is just one more feather in it's cap!